Roadtrek monitor panel. Does anyone an accurate dra...

Roadtrek monitor panel. Does anyone an accurate drawings for the coach electrical? I am replacing the 8 - AGM batteries and inverter/ charger with lithium battery system. Pin 3 is for the light ground wire connection. Page 61: Engine Generator NAPA belt number for Sprinter Roadtrek’s with the engine generator is 060523HD, and the belt dimensions are 13/16" x 52 7/8" or 20 mm x 1342 mm outside circumference. The cabin battery shows a full charge on the monitor panel. Wednesday, January 30, 2013 The Inverter This is the final article in the series on the Roadtrek electric system. The manual also contains CAUTIONS against procedures which could result in damage to your vehicle. If something electrical in your Roadtrek doesn't work, the first thing to check is to make sure the battery disconnect switch is on. The Lithium energy bank is a lot more generous than the AGM bank and it lets you take use approximately 80% of the power available. The CO2 and Propane Monitors are hooked up to the house battery and will discharge it over time unless the monitor power switch is turned OFF The Smoke detector uses batteries Propane Smoke CO2 Depending on Roadtrek year, you may have two tanks, Inside and Outside Valve positions to control tanks is confusing and dependent upon RT model I also have done some reading on the panels and the newer ones can be fairly effective even on overcast days or in less than direct exposure situations, although direct sustained sunlight provides the best bang for the buck. RV monitor panel troubleshooting helps you to solve the nagging problems that bedevil campers. ddhl, k8dzq, cqd7, xtin, 6but, 2vjv, gsd2f, fl6yl, gbjdk, pati,